does any one know were to get parts, like tires,and a riser block,it looks allmost identical to a 14 delta,but a new current delta riserblock is notched for a bolt the old saw is. Hi all I traded some work for a old delta/milwaukee band saw. Real nice newer complete Jet about 1 hr away just listed for $500. woodshaver Posted in Power Tools and Machinery on J08:27am. Knew I shouldn't have done it, but looked for standard bandsaw search on FB Marketplace yesterday for fun. Going to take a few weeks to get this back together. Probably be about $600 into into by time all fixed up, and will have made lots of little things (adjuster knobs for upper guides, lock collars for lower guides, table insert, table align pin, make long tension rod and hardened nut, couple bushings, and return a couple steps on the new pulleys to make belt fit every step the same). Have it all torn apart, with replacement parts / bearings arriving this weekend. Rest of unit was well used / abused and jerry rigged. 1996 14' Wood Cutting Band Saw (Model 28-280) The Serial No./Model No. 426-0 ©Delta International Machinery Corp. Will be replaced with HF 1 hp compressor motor(still have $100 gift card). INSTRUCTION MANUAL DATED 1-15-96 PART NO. Since original motors were 1725 rpm, it is going away without replacing the cap. Motor does not run, just hums, wired for 220, and 3450 rpm, with capacitor rated 110 v. (1) column blade guard interchanges with Part NumberLBS-190. From the three pictures, was obvious it was missing both step pulleys and upper blade guide at minimum, so took a chance for cheap. See my other Delta Bandsaw parts like (1) Cast iron riser block interchanges with Part NumberLBS-28. Something had to change, so said I would buy next one I saw.įinally bought a 'no information available - never been run powered up since purchased' well used 1974 Rockwell 28-300 at a local auction, 20 minutes away, for $60 2 weeks ago. Recently did major repairs to rusty mower deck on my Gravely Pro walk behind, and very tired of the cut-off wheel and jig saw for 1/8 sheet. Most were in $600-1000 range, and several still needed work. Wanted a ready to use one, not a basket case. I have been looking on/off for last 2 years here on east coast for metal / wood saw.

Delta milwaukee band saw riser